*PLEASE DO NOT ORDER UNTIL YOU READ THE FULL DESCRIPTION. THESE ARE NOT RETURNABLE NOR EXCHANGEABLE*
NISformance Oxygen sensor extension harness for primary oxygen sensors. We make four different types. Please see description of each below.
These are completely plug and play !!! While installing long tube headers on a 370Z we decided to make plug and play extensions instead of splicing into the engine harness. This solution offers a much cleaner, easier, and faster install. No need to cut or solder any wires !!! Avoid a potential wiring nightmare with these extensions.
LOOK AT THE PICTURES TO SEE WHICH TYPE YOU NEED TO ORDER WHEN LOOKING AT TAB LOCATION MAKE SURE THE CONNECTORS ARE IN THE SAME ORIENTATION AS PICTURED
Type 1- rectangle with side tabs near the bottomIncludes:
Type 2- square with left side tab near bottom right side tab near top
Type 3- square with side tabs near bottom
Type 4- square with side tabs near top
- Two harness extensions (SOLD AS A PAIR, NOT INDIVIDUALLY)
- HR 350z
- HR G35
- Q50 (VHR)
- Q60 (VHR)
THIS ITEM IS NOT RETURNABLE!!!
THIS ITEM IS NOT EXCHANGEABLE!!!
MAKE SURE THESE CONNECTORS MATCH UP TO THE CONNECTORS ON YOUR VEHICLE / O2 SENSOR BEFORE ORDERING!!!!!!!
NOTE: ORDER QTY OF 1 INCLUDES A PAIR OF EXTENSIONS. THESE ARE SOLD AS A PAIR, NOT INDIVIDUALLY.
IF YOU REQUIRE A REFUND FOR INCORRECT QTY ORDERED, A 3% FEE WILL BE APPLIED. ONCE YOUR ORDER HAS SHIPPED, THEY ARE NO LONGER RETURNABLE.